Introduction to ABS Solar Road Studs

Description

Benefits:

• Safety Improvement: Significantly reduces the risk of accidents at rail crossings, intersections, and other critical areas by alerting drivers in advance.
• Environmental Impact: Utilizes solar energy, reducing reliance on non-renewable power sources and minimizing environmental footprint.
• Cost-Effective: Saves on electricity and maintenance costs due to durable construction and renewable energy usage.

Working Principle of Solar LED Road Stud:

• Energy Conversion: Solar panels on the studs absorb sunlight and convert it into electrical energy, stored in batteries or capacitors.
• Automatic Lighting: At night or during bad weather, the stored energy is converted into light by LEDs, triggered by photoelectric switches. This process ensures efficient use of energy and continuous operation.
• Visibility Enhancement: Bright, flashing LEDs provide high visibility, alerting drivers well in advance compared to traditional road studs.

Installation Method:

1. Site Preparation: Identify and clean the installation area to ensure a flat surface.
2. Adhesive Application: Apply an even layer of epoxy glue to the bottom of each stud.
3. Placement: Press the stud onto the road surface, ensuring it is fixed in the correct position.
4. Inspection: Check the studs within 2 hours of installation to ensure they are correctly aligned and securely attached.
5. Final Steps: Remove any barriers or isolation facilities 6-8 hours after installation to facilitate normal traffic flow.

Recommended Spacing:

• Highways and Expressways: Approximately 5-6 meters (7-8 yards)
• Dangerous Entrances and Exits: Approximately 2-3 meters (4-5 yards)
• Hospital and Parking Lot Access: Approximately 0.5-2 meters (0.5-3 yards)

Applications:

• Urban Roads: Enhances driver visibility and safety in urban settings.
• Parking Lots: Provides clear lane and boundary indications, improving navigation and safety.
• Gardens and Roadsides: Offers aesthetic and practical lighting to illuminate paths and enhance security.

Key Features:

• Durability: Ultrasonic welding ensures the components do not easily fall off and are well-sealed against elements.
• Longevity: Designed to last over 10 years with super power capacity.
• Efficiency: Capable of recharging fully to support 180 hours of flashing or 40 steady hours during foggy or rainy conditions.
• Customization: Available OEM/ODM options to meet specific customer requirements.
• Reliability: Tested to work normally for more than 3 years under typical conditions.

Specification :